Kv2-audio COMPEX Bedienungsanleitung PDF herunterladen (Seite 6)

Unpacking

Unpack the COMPEX and check to see if there

is any damage to it. If you find any damage

notify your supplier immediately.

Only the consignee may institute a claim with

the carrier for any damage incurred during

shipping. Be sure to save the carton and all

packaging materials for the carrier’s inspection.

Should you ever need to ship the unit, only use

the original factory packaging. If the shipping

carton is unavailable, contact your supplier to

obtain a replacement.

The COMPEX carton should contain:

s#/-0%83UPER!NALOGUEUNIT

s5SER'UIDE

s)%#0OWER#ABLE

Rack mounting

The COMPEX will mount in a standard 19”

rack system. Use four screws and washers to

mount the COMPEX to the rack rails. We

recommend using a shock-mounted rack for

touring use to prolong the life of your

COMPEX.

To prevent accidental adjustment of settings,

or unwanted tampering in a fixed installation,

+6!UDIOPROVIDEANADDITIONALSECURITYPANEL

AC Power requirements

The COMPEX USESASTANDARD)%#POLE!#

connector. The device must be connected to a

mains socket outlet with protective earthing

connection. The COMPEX operates in either

115V or 230V mode. This setup is preconfigu-

red at the factory. The mains plug of the power

supply cord shall remain readily operable.

Getting started

AUTION

!

Voltage requirements

The COMPEX operates safely and without

AUDIODISCONTINUITYIFTHE!#VOLTAGESTAYS

within the operating window of 90V-130V in

115V mode or 180V-260V when working in

230V mode at 50 or 60Hz.

Input Output

12

3

21

3

1 = Ground

2 = Hot (+)

3 = Cold (-)

Connector wiring

XLR Balanced Input and Output connectors

CAUTION:

)FTHE'REENOR2EDBYPASS/N

LED does not illuminate or the

system does not respond to audio

INPUTREMOVE!#POWERIMMEDIA-

tely. Verify that the voltage is

within the proper range. If the

problem persists, please contact

+6!UDIOORANAUTHORIZED

service center.

!

CAUTION

CAUTION:

If it is necessary to convert balan-

ced output to unbalanced, it is

IMPOSSIBLETOSHORT(OTOR

#OLDPINSWITH'ROUND)N

this event the Line Drivers will

cause permanent disconnection.

!

CAUTION

Page | 6

Jack 1/4” mono

switch

Remote bypass control wiring

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare